Conversely, it does not make sense to set maxvgs to a low value since it will likely have to be raised later when a greater number of volume groups is utilized. Thanks guys I ran following commands which fixed my problem. The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
End of content United States. Hewlett Packard Enterprise International. From what I understand, when you are defining the minor number ie: 0x , the last 4 digits should be and the first 2 are according to the name of the vg. So, if it is vg09, it would be 0x That's what the documentation states, but I'm not sure if that's convention or a requirement. Exalted Contributor. I got this message during Service Guard Class. I had mistyped the name group when I ran the mknod command.
I removed the directory and did it again without the typo and everything was fine. Valued Contributor. Changes in parameters with these options can be seen in vgdisplay output which you can see incoming section. Same as pvdisplay command, vgdisplay is used to view VG details.
The above output is pretty self-explanatory. It also shows PV details which are part of this VG. This command used the below options :. Normally we use vgscan -v only. Once you create the physical volume, you can create the volume group VG from these physical volumes PV. LVM processes the storage in terms of extents.
We can also change the extent size from the default size 4MB using -s flag. Now, everything is ready to create the logical volumes from the volume groups. After creating the appropriate filesystem on the logical volumes, it becomes ready to use for the storage purpose. We can extend the size of the logical volumes after creating it by using lvextend utility as shown below. The changes the size of the logical volume from 80MB to MB. This article is very good. Please tell how to reduce the logical volume successfully.
When the partition is already in use and you are reducing it, you first have to reduce the filesystem e. Otherwise you are running under serious risk of loosing your data! Nice article, an example of assigning entire disk can someone. Nice article, an example of assigning the entire disk. The 1. This is a human-readable output to give you a general idea of how big the VG is. If you want to specify an exact size, you must use extents instead of some multiple of bytes. This tell vgs to add the free extents and the total number of extents to the end of the vgs listing.
Use the free extent number the same way you would in the above vgdisplay case. I have a CentOS 6. Can anyone here provide me with the proper method?
0コメント